D.C al Fine and voltas
I have made a little dummy score to illustrate my problem. I want that at the first round it should play bars 1, 2, 4, 5 and 6. When repeating, it should start at the beginning and play bars 1 and 3. Then it should end. How to do this? I have tried different methods without success. Thank you in advance.
| Attachment | Size |
|---|---|
| dc_al_fine_and_voltas.mscz | 5.56 KB |
Comments
1st Volta, only works with (or depending on) End Repeat Barline. :||
example: 1.st Volta :|| 2.nd Volta
You shouldn't use it independently.
https://musescore.org/en/handbook-notation/voltas
For other Repeats and Skips, you should review the "Repeat Symbols / Texts" such as "Dal Segno" and "Da Capo", "Coda", etc.
https://musescore.org/en/handbook/repeats-and-jumps#repeat-symbols-and-…
I assume this is a representation of what you wish to do, so have a look at this:
dc_al_fine_and_voltas2.mscz
Regards.
In reply to I assume this is a… by Jm6stringer
Thank you all. Of course I have read the handbook about repeats, but I did not understand how to use them in my case. Fortunately Jm6stringer solved it. Still I need advice about your solution. I don’t understand how did you put that coda bar inside of a horizontal frame.
In reply to Thank you all. Of course I… by simmarama
Actually, it is 2 horizontal frames, and not the coda bar inside a single horizontal frame.
The first horizontal frame is inserted before the coda bar, the second is appended after the coda bar.
Normally, codas are shown with some distinction (e.g. small separation) from the rest of the score, so I inserted the first frame to provide some indentation for the coda's beginning.
The appended frame adjusts the measure's stretch across the page, but may not be necessary if the coda has more than one bar in the 'real' score. After all, this is a 'dummy' score, and only a representation of the relevant repeat/jumps scenario.
Regards.
In reply to Actually, it is 2 horizontal… by Jm6stringer
Thank you very much, now it works as it should. Where would we be without forums like this?
If you want 1.2.4.5.6 and 1.3 END
Look ligne 3 and 4
dc_al_fine_and_voltas3.mscz