Guitar TAB Voices with Stems and Beams
I am a new MuseScore user and after reading the manual sections on tablature and voices, and searching this forum I have a question.
I have imported a 4 voice guitar TAB which I made in Guitar Pro 6 but MuseScore is showing beams and stems for all 4 voices. Is it possible to show these only for voice 1?
Comments
Select the stave, open Inspector (F8) select 'Stemless'?
use selection filter if necessary (F6)
In reply to Select the stave, open… by Shoichi
That will turn the stems off for all voices including voice 1.
The only thing I can think of is to use the selection filter (F6), uncheck Voice 1, select the staff, click the Notes button in the inspector (F8) and then check Stemless.
In reply to That will turn the stems off… by mike320
depends on whether there are 4 voices and one stave or 4 voices and four staves, it seems to me...
In reply to depends on whether there are… by Shoichi
1 TAB stave with 4 voices.
In reply to Select the stave, open… by Shoichi
Thanks, I'll try that out tomorrow. Is it a note by note setting or can I apply it to a whole voice in one go? As I said, I am new to MuseScore and there's a lot to learn!
In reply to Thanks, I'll try that out… by yonah_ag
https://musescore.org/en/handbook/selection-modes#range-select
HTH
In reply to https://musescore.org/en… by Shoichi
Certainly does. Many thanks.
In reply to Thanks, I'll try that out… by yonah_ag
In reply to [inline:18060603.png] by Shoichi
Looks good to me. Will have a play tomorrow. :-)
In reply to Looks good to me. Will have… by yonah_ag
Thanks Shoichi, that worked perfectly.
:-)