Mixer
Is it possible to set mixer to set the volume for individual voices on a stave? I'm writing for a choir, and would normally write SATB on two staves, but for rehearsal I would need to separate voice 1 and two on each stave.
Do you still have an unanswered question? Please log in first to post your question.
Comments
No you can't use the mixer for that. There is a workaround.
Select the measures you want to adjust if other than the entire voice. You can right click a note in the voice you want to change the volume then use select>more... then in the same voice, (and in selection if only some of the measures need adjusted) this will select all notes in that voice, You can then increase or decrease the Velocity for all of those notes. The velocity, if Velocity type is offset, will increase or decrease the volume it would otherwise play at. Negative numbers will decrease the volume and all numbers must be between -127 and 127. For a point of reference p=49 and f=96.
In reply to No you can't use the mixer… by mike320
Mike, that's brilliant! Many thanks for the advice.