Bug in "Re-Pitch" mode...

• May 29, 2019 - 01:09

Hi, after setting the rhythms with rhythm mode, I go to re-pitch mode to set the pitches.

There is this problem: I can set octaves or double stops per each of the rhythms entered, without any problem, EXCEPT FOR NOTES THAT CROSS A BARLINE.

Once a note crosses a barline, something completely unexpected happens: suppose I have 1 eighth note tied to another eighth note in the following bar, when I re-pitch it with a double stop, ONLY THE VALUES AFTER THE BARLINE get all the notes, and in the value before the barline, ONLY THE BOTTOM OR TOP NOTE REMAINS. bug1.png

Comments

• May 29, 2019 - 11:04

Thank you for the prompt reply. I input the notes with a midi keyboard.

It would be great if it could be implemented that in the same way re-pitch can turn any rhythm into either single notes or complete chords, it would behave in the same manner when it crosses a barline, instead of forcing monophony on the left side of the tied over rhythm and leaving it polyphonical on the right side. I have seen there is a workaround, but it gets very tiresome if you have these happening all the time, by entering separate eighths and doing the ties later...

I was thinking, maybe there is another workout in that I can write in 4/2 or 8/4 and then rebar once the piece is complete into 2/2 or 4/4? Since most of the work I do is for Latin music, and there is always a tied note over the barline every two bars. I am new to muse-score, is it easy to re-bar a musical content into another time signature with this software?

Thank you a lot Marc, all the best,

Reply

Do you still have an unanswered question? Please log in first to post your question.