Chord input problems
Hi, I'm transcribing a jazz lead sheet and putting Chords over a melody. I know that Ctrl+K is used after selecting a written note value to place the chord, but what if I want to place the chord on a note value not written in the measure? To give an example I have a whole note on a measure of 4/4 and want to place two chords on beats 1 and 3. Please get back to me at your earliest convenience.
Thanks.
Comments
In you example writing the first chord and then pressing the blank key should jump to beat 3 - at least in MS 3.6.
In reply to In you example writing the… by gerb1857
I see I just needed to hit space after writing the first chord. Thanks :)
In reply to I see I just needed to hit… by finncoover
Here are the instructions in the MS 3.6 Handbook for for navigation while entering chord symbols:
Keyboard commands for navigation
Space for next beat or note, semicolon for just next beat.